● High dual guide rails made of aluminum, Hard anodized surface
● Resistance to dirt with LIN liners
● Weight saving and no noise
● Simple installation, maintenance-free
● Standard fitting width
● Maximum 2:1 ratio
● 1x = bearing separation on same shaft
● 2x = distance from shaft to load or force
● CAUTION: uneven motion or even system blockage will occur if the 2:1 ratio is exceeded !
This principle is NOT load dependent! It is NOT due to edge loading. It is also NOT dependent on the driving force used! The greater the distance between the drive and guide bearings, the higher the degree of wear and required drive force.
There may be other factors that add to the braking effect, but the coefficient of friction is the main cause.
● NOTE: The Rule(2:1) is based on the static friction value of 0.25 theoretically, However, Additional lubrication can help to drop friction and extend the 2:1 ratio.
● Opening design sliding liners
● Self-lubricating and dust resistance
● Made of anti-wear material EPB13,MN2,EPB5
● Fitted standard liners EPB13
● Maintenance-free, dry-running
● Fast assembly and light weight
more● Fitted standard liners EPB13
● Maintenance-free, dry-running
● Fast assembly and light weight
more● MN2 liners for aluminum shafts
● Maintenance-free, dry-running
● Fast assembly and light weight
more● Wear layer material: TEFPLAS® B
● Operation temperature ±200℃
● Max. continuous running speed 1.5m/s
more● Rolling and sliding hybrid carriages
● Smooth moving and driving force reduced 45% than the standard carriages
● Sliding liners material: EPB13
● For side installation of WR02 guide rails
more● Rolling and sliding hybrid carriages
● Smooth moving and driving force reduced 45% than the standard carriages
● Sliding liners material: EPB13
● For horizontal installation of WR02 guide rails
more691
▊CSB-LIN® Plastic Linear Bearings Finder[V2.0] including LIN plastic linear bearings and LINP precision linear bearings. The system is based on the analysis and calculation of a large number of test data in CSB® laboratory. You can calculations bearing data by entering parameters such as bearing load, speed, temperature and position information, The system will output bearing adaptation data and min. driving force.
▊Because the system calculate and analyze based on lab data, it can't exactly meet the ractual use requirements absolutly. The system data verification has certain limitations; CSB® recommends that the bearing must be tested again to verify whether it meets the actual use requirements.
▊CSB-LIN® Plastic Linear Bearings Finder output data information is only for design reference, and can not be used as the final standard for determining the bearing material conformity, If you have any questions, please contact CSB® sales engineers.
AS: Hard anodized aluminum shaft, the best shaft for LIN linear bearings; CS: Hard-chromed steel shaft, the effective-cost shaft; ES: 304 Stainless steel shaft, the best for chemical liquid; Shaft end processing service...
moreCompact and low high design support;
Standard design support;
3 materials shaft: Hard anodized aluminum shaft, Hardchromed steel shaft, 304 Stainless steel shaft;
more● Single guide rails made of aluminum
● Hard anodized surface
● Weight saving and no noise
● Variable width can be fitted
more● Single guide rails made of stainless steel 316Ti
● Good corrosion resistance
● Resistance to dirt with LIN liners
● Variable width can be fitted
more● Dual guide rails made of stainless steel 316Ti
● Good corrosion resistance
● Resistance to dirt with LIN liners
● Standard fitting width
more