● Aluminum alloy material and low weigh
● Standard design, fixed from the bottom
● With locking screw, easy to install
Polymer-tech SolutionsTM
The shaft support block is used for shaft end fixing, inculding standard and flange design with locking screw, made of aluminum alloy and low weight. The flange design used for fixed from the side and smaller installation space than the standard design.
● Aluminum alloy material and low weigh
● Standard design, fixed from the bottom
● With locking screw, easy to install
● Aluminum alloy material and low weigh
● Flange design, fixed from the side
● With locking screw, easy to install
● Aluminum alloy material and low weigh
● Flange design, fixed from the side
● With locking screw, easy to install
● Aluminum alloy material and low weigh
● Standard design, fixed from the bottom
● With locking screw, easy to install
● Aluminum alloy material and low weigh
● Narrow design, fixed from the bottom
● With locking screw, easy to install
● Aluminum alloy material and low weigh
● Narrow design, fixed from the side
● With locking screw, easy to install
● Aluminum alloy material and low weigh
● Round flange design, fixed from the side
● With locking screw, easy to install
● Aluminum alloy material and low weigh
● Square flange design, fixed from the side
● With locking screw, easy to install
● Aluminum alloy material and low weigh
● Flat flange design, fixed from the side
● With locking screw, easy to install
● High corrosion-resistance
● Also completely supported and assembled with standard aluminium support
● Good solution for the applications under wet environment
● Cost-effective steel shafts
● Also completely supported and assembled with standard aluminium support
● C45 steel, hard-chromed
● Material: AL 6061/6060
● Surface: hard anodized
● Straightness: EN 754-3
● Solid and hollow shafts are available